Connecting to the camera via Wi-Fi

Operate the camera to initiate the Wi-Fi connection

1. Press the camera's [MENU] button to display the menu.

2. On the MENU screen, select [Network settings] on the tab below.



3. Select [Network] and set to [Enable].

4. After selecting [Connection settings], select [SET] under [Unspecified].

5. Select [Create with wizard].

6. Select [Configure online] and then [OK].

7. Select [Smartphone] and then [OK].

8. Select [Wi-Fi] and then [OK].

9. Select [New settings] and then [OK].

10. After selecting [Camera access point mode], select [Easy connection] and then [OK].

11. Select [OK] to save the settings.

12. Confirm what is displayed on the camera and then select [OK].

• Only the settings are saved. The connection is not yet complete. Please proceed to the next step.

13. Select [New settings] and then [OK].

• The camera's screen enters the connection standby state.

This concludes the camera operation.

Please close these instructions and proceed to the next screen.